The sawtooth star is an attractive, traditional quilt block that does not have to be hard to make. Follow these foolproof instructions for all skill levels to make a 6.5″x6.5″ block.
These instructions will make a 6.5″x6.5″ sawtooth star block with 1/4″ seam allowances, so the finished block size will be 6″x6.”
Note: These directions make the blocks a little big and have you trim them down. This method works for any level of quilter but is especially foolproof for beginning quilters.
Prepare your Fabric
Pre-wash your fabric, if needed.
Then, using a rotary cutter and rulers on a cutting mat, cut squares and triangles as follows:
- One 3.5″ square in C (for the center)
- One 4.5″ squares in D (for the flying geese)
- Four 2.5″ squares in B (for the flying geese)
9 Cutting Tips: Prevent Mistakes while Cutting Quilt Fabric
Sew four 2″x3.5″ flying geese blocks
Make four smaller flying geese quilt blocks.
Assemble the Sawtooth Star block
Lay out your 9 blocks (4 flying geese, 4 corners, one center block) as follows:
- First row: One small background square, one flying geese with the background edge facing up, and one small background square.
- Second row: One flying geese with the background edge facing left, center square, and one flying geese with the background edge facing right.
- Third row: one small background square, one flying geese with the background edge facing down, and one small background square.
Sew each row
Sew the first row together, with a 1/4″ seam allowance.
Press seams open.
Measure this row to make sure it’s 6 1/2″ wide. If it’s not, double check your seam allowance, rip out your seams, and try again. If it’s thinner than 6 1/2,” try moving the needle on your sewing machine a tad to the right to make your seam allowance smaller. You’ll want to measure the other pieces as the block comes together, but this is the best place to correct the problem (before you sew the rest of these seams!).
Sew the second row together with a 1/4″ seam allowance, taking care to match up the points exactly in the center of each seam.
Press seams open.
Sew the third row together, like the first.
Press seams open.
At this point, three rows have been sewn together. You’re almost done!
Sew rows together
Sew the first row to the second row with a 1/4″ seam allowance, taking care to match up the points exactly in the center of each seam. I like to pin the two rows at this point.
Press seams open.
Sew the second row to the third row with a 1/4″ seam allowance, taking care to match up the points exactly in the center of each seam.
Press seams open.
Measure to make sure block is exactly 6.5″x6.5″. It should have 1/4″ seam allowances on every side, and there should be 6″ from side to side in both directions.
If it is not the right size, measure each piece to figure out what went wrong, rip back, redo that, and sew the block back up again. Think of it as practice to help you get better at quilting.
You should now have a finished 6.5″ sawtooth star block! Well, it still has raw edges, because there is a seam allowance. That is okay; it will be sewn to something else later, and will look perfect.
1 Comment on “How to Sew a 6.5″x6.5″ Sawtooth Star Quilt Block”